Docomo F-01E Instruction Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 148
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
Introduction
These precautions are based on the guidelines
produced at the Electromagnetic Compatibility
Conference Japan, regarding the protection of
electronic medical equipment from radio waves
emitted by mobile phone units.
WARNING
Obey the following rules inside medical
facilities.
Do not bring FOMA terminal into operating
rooms (ORs), intensive care units (ICUs) or
coronary care units (CCUs).
Turn FOMA terminal OFF in hospital wards.
Turn FOMA terminal OFF in hospital lobbies
and corridors if electronic medical equipment
could be nearby.
If the medical facility has specified zones
where use or possession of mobile devices is
prohibited, obey those instructions.
If the function to automatically turn ON the
power is set, cancel the setting before turning
the power OFF.
Turn FOMA terminal OFF in crowded
trains or other public places where
pacemaker or defibrillator wearers
could be nearby.
FOMA terminal's signals may affect the
operation of implanted pacemakers or
defibrillators, and other devices.
Wearers of electronic medical
equipment such as implanted
pacemakers or defibrillators must carry
and use FOMA terminal at least 22 cm
away from the implanted device.
FOMA terminal's signals may affect the
performance of electronic medical equipment.
When electronic medical equipment
other than implanted pacemakers or
defibrillators are in use outside of
medical facilities (such as in home care
settings), check with the device
manufacturer to determine how the
device is affected by electrical signals.
FOMA terminal's signals may affect the
performance of electronic medical equipment.
Handling mobile phones near
electronic medical equipment
Do
Do
Do
Material list
Part Material
Surface
treatment
Exterior
case
Movable part
Sub-Display
PC+GF resin
UV hard coating
Movable
part Display
PA-GF resin
UV hard coating
Fixed part
Keypad
PA-GF resin
UV hard coating
Fixed part
Battery
PC+ABS resin
UV hard coating
Hinge section
Movable side
PC+ABS resin
UV hard coating
Hinge section
Fixed side
PC+ABS resin
UV hard coating
Back cover PC+ABS resin
UV hard coating
Back cover
plate
PC sheet,
silicon rubber
None
Back cover
lock lever
POM resin Engraving
Back cover
lock plate
Stainless steel None
Case pad Urethane resin None
Display panel High-intensity
acrylate resin
UV hard
coating
Back panel Acrylate
resin+PC resin
UV hard coating
Do
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 147 148

Comments to this Manuals

No comments